Friends who have used a steel bar cutting machine should know that the saw clip of the steel bar cutting machine plays a major role in the circular saw. A guide to ensure the linear movement of the saw blade. In order to improve the quality of circular saw products and ensure safe production, the gap between the saw blades of the steel bar cutting machine must be properly adjusted. So how to find the gap between the saw clips of the rebar cutter?
What is the proper clearance between the rebar cutter saw clamps?
If the gap between the saw clamp and the blade of the rebar cutter is less than 0.15mm, there is no significant difference in amplitude between the running saw and the blade. If the gap between the clamp and the blade exceeds 0.2 mm, the amplitude of the running saw and blade will increase significantly. However, if the gap between the rebar cutter and the saw clamp is too small, it will increase power consumption and it will be difficult to start the saw. Usually 0.1-0.15 mm is suitable.
According to the common past experience of steel bar cutting machines, the saw blade should not be blocked by hand, and the saw blade should be held gently instead of being "tightly fixed" on the saw blade. Everyone must pay attention when using it! The material of the rebar cutter saw clips can be hard broad wood and should be soaked in oil. After the oil bubbles, the saw blade can be used to lubricate, with less wear and long service life.
