Different from the traditional steel bar cutting machine, the CNC steel bar straightening and cutting machine uses a computer chip to control the system. This kind of machine integrates the machine, electricity and gas into a whole, and the operation of this skill requires professional practitioners to operate. , otherwise it is very prone to security problems. Fully automated machinery and equipment have high requirements for operation and maintenance. If you want to extend the service life of the CNC steel bar straightening and cutting machine, the training of operation safety guidelines bears the brunt.
When the CNC steel bar straightening and cutting machine officially starts to operate, the operators need to wear relevant safety protective gloves and safety helmets. Before starting the machine, properly add some grease to the parts of the machine for buffering. Next is the inspection part. Among them, the inspection of each box is the core, and the inspection of the lubricating oil in the reducer. Sufficient lubricating oil can reduce the wear and tear of the reducer during operation. The other is the inspection of the screws of the machine parts. The loose screws look inconspicuous, but the CNC steel bar straightening and cutting machine is a high-intensity use process during the operation. Once it starts, if it is interrupted, it will cause great machine wear and tear. So the inspection of screws is a very critical detail. The last is to check the power switch, all the trachea.
In the operation process of the CNC steel bar straightening and cutting machine, it should be carried out in steps, and then first test whether the machine can work normally. When the online start, the operator's body and hands can not touch the machine, to avoid accidents to the greatest extent possible. There will also be an emergency stop switch on the operating table of the machine. This switch should leave a controllable range, so that the machine can be effectively controlled at the first time when a problem occurs.
