General machinery and equipment need to be maintained at ordinary times, and steel bending machines are no exception.
Before using the steel bar bending machine to process the steel bar, the steel bar bending machine must pay attention to the idle operation first. After the speed is normal, the end of the steel bar that needs to be bent can be inserted into the gap fixed by the turntable, and the other end of the steel bar needs to be pressed by hand, and then the steel bar is pressed. The bending machine is fixed so that it is safe to bend on the side that blocks the rebar.
The operation process of the rebar bending machine:
First of all, everyone should pay attention to preparing all kinds of mandrels, and then check whether the mandrels, blocks, and turntables are damaged or cracked, and whether the protective cover is fastened here. Secondly, when bending the steel bar, the steel bar must be close to the baffle plate. When the steel bar bending machine is running, it is not possible to replace the mandrel, the pin, change the angle, and adjust the speed. Unnecessary hazards can be avoided.
In addition, when the steel bar bending machine bends steel bars, if the diameter and number of steel bars exceed the specified speed of the machine, do not do it. When turning around and bending, in order to avoid hitting people and things, everyone should pay attention to replacing the plug. If you want to Refueling and cleaning must be done after the machine has stopped running.
