1. Before use, please check whether the blade is cracked and whether the blade fixing screw is tightened. Are the guardrails on the side of the pulley and the protective cover of the transmission in place? The aircraft shell must be grounded to prevent leakage and injury.
2. If the horizontal steel bar cutting machine does not reach the normal speed, please do not cut the material. Pay attention to the gap between the blades when cutting, hold the rebar with both hands, feed quickly, and press firmly against the side of the blade. Do not allow material to be supplied against either side of the blade.
3. It is forbidden to cut steel bars and hot steel bars whose diameter exceeds the mechanical regulations. If you want to cut multiple bars at once, you need to convert the bars.
4. When the horizontal steel bar cutting machine cuts special steel bars such as low-alloy steel, it is necessary to replace the high-hardness blade and convert it according to the specified machine diameter.
5. When the steel bar cutter cuts short materials, the length of one end of the hand must be at least 40 cm, and the safe distance between the hand close to the blade and the blade is at least 15 cm. If the cutting length of the steel bar is less than 30 cm, the short end must be pushed with a sleeve or a clip before cutting to avoid bouncing or hurting people.
6. When cutting long steel bars, it is necessary to designate someone to help cut the steel bars. The person supporting the rebar must act in the same way and follow the instructions as the person holding the machine. They should not be pulled or pulled at will.
7. When the steel bar cutting machine is running, it is strictly forbidden to directly remove the broken ends or debris near the cutter head by hand. Non-operators are not allowed to stay within the swing range of the rebar and near the knife edge.
8. If the horizontal steel bar cutting machine fails, makes noise, or the blade is deformed, loose or broken, please turn off the power immediately and stop maintenance. It is strictly forbidden to overhaul the running machine. It is strictly forbidden to overhaul the running machine.
9. The cut semi-finished products should be put away. Prevents individual new cuts from sticking out and scratching the skin.
10. After the work is completed, turn off the power, lock the switch box, clean the work site, wipe the machine and add grease.
